Heavy Duty Soldering
Electronics Forum Index Electronics
Circuits, theory, electrons and discussions.
 
 FAQFAQ   MemberlistMemberlist     RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 
 
Google
 
Web ElectronicsHelp.net
Heavy Duty Soldering

 
Post new topic   Reply to topic    Electronics Forum Index -> Electronics General
Author Message
R Adsett
Guest
Posted: Fri Feb 11, 2005 11:21 pm    Post subject: Heavy Duty Soldering Reply with quote
I have an assembly that uses Cu bus bars 1.55 mm thick connected to a 3
oz Cu plane on PCB via through hole pins 1.5mm wide. So that gives pins
about 1.5 mm sq.

The problem I have is that with the iron I'm using at the moment the
combined heat sinking of the Cu plane and the Cu bus bar is too much for
the iron to overcome. I'm looking for something that would be
appropriate. I've used American Beauty heavy duty Irons in the past for
similar purposes but I'm wondering if any one has other (perhaps better)
suggestions.

Robert

Back to top
 
Post new topic   Reply to topic    Electronics Forum Index -> Electronics General All times are GMT
Page 1 of 1

 
 You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



Home & Living New Topics
Contact Us
Powered by phpBB