| Author |
Message |
ken
Guest
|
 Posted:
Sun Jan 30, 2005 11:41 pm Post subject:
Orcad newbe question |
|
|
Hi all,
Can I run a simulation and view the schematic to see what's going on
i.e., current flow, voltages, etc. in different parts of the circuit.
Much the same way MicroCap allows you to view the schematic when
running a simulation.
Thanks for any help, Ken
|
|
| Back to top |
|
 |
Jim Thompson
Guest
|
| Posted:
Mon Jan 31, 2005 12:41 am Post subject:
Re: Orcad newbe question |
|
|
On Sun, 30 Jan 2005 12:41:30 -0500, ken <somewere@out.there> wrote:
| Quote: | Hi all,
Can I run a simulation and view the schematic to see what's going on
i.e., current flow, voltages, etc. in different parts of the circuit.
Much the same way MicroCap allows you to view the schematic when
running a simulation.
Thanks for any help, Ken
|
You'll have to page back-and-forth between the Probe view and the
Schematic view, UNLESS you have dual monitors.
Waveforms are shown in Probe, NOT on the Schematic. But bias
conditions can be seen on-schematic using the "V" and "I" buttons.
...Jim Thompson
--
| James E.Thompson, P.E. | mens |
| Analog Innovations, Inc. | et |
| Analog/Mixed-Signal ASIC's and Discrete Systems | manus |
| Phoenix, Arizona Voice:(480)460-2350 | |
| E-mail Address at Website Fax:(480)460-2142 | Brass Rat |
| http://www.analog-innovations.com | 1962 |
I love to cook with wine. Sometimes I even put it in the food. |
|
| Back to top |
|
|
ken
Guest
|
| Posted:
Tue Feb 01, 2005 2:05 am Post subject:
Re: Orcad newbe question |
|
|
On Sun, 30 Jan 2005 11:41:12 -0700, Jim Thompson
<thegreatone@example.com> wrote:
| Quote: | On Sun, 30 Jan 2005 12:41:30 -0500, ken <somewere@out.there> wrote:
Hi all,
Can I run a simulation and view the schematic to see what's going on
i.e., current flow, voltages, etc. in different parts of the circuit.
Much the same way MicroCap allows you to view the schematic when
running a simulation.
Thanks for any help, Ken
You'll have to page back-and-forth between the Probe view and the
Schematic view, UNLESS you have dual monitors.
Waveforms are shown in Probe, NOT on the Schematic. But bias
conditions can be seen on-schematic using the "V" and "I" buttons.
...Jim Thompson
|
Thanks for the help Jim.
Ken
|
|
| Back to top |
|
|
|
|
|
|
FAQ
Memberlist
Register
Profile
Log in to check your private messages
Log in