Electronics

Tdk420n · Joined: 28 May 2006 Posts: 1 Location: Kennett Square, PA

I am trying to make a Nixie tube clock and want to have a circuit board made for it, rather than just using a bread board. I have the component layout schematic for the copper side and want to know if anyone can make me the board. Or if there are any companies that can make it for me.

neon · Joined: 25 Feb 2006 Posts: 590

you may make it yourself, two way to go laquer and paint it yourself if you are good at it. I do it all the time I hate pcb made it cost too much for small items. There is press and peel.all you need is an iron 300 watts and you transfer your design to press and peel transfer your design with a copier and press and peel. it is the best and for $10 you got 40 by 50" of pcb not bad and it looks good too. well you need ferric chloride too for etching . two hours you are done. elexp.com will sell you all that you need. if you find somebody that does it in small quantity it means somebody working in a carage some place.

	Electronics Forum Index -> Design	All times are GMT
Page 1 of 1